Product ID:OUTBOUND RESIN BONDED ADHESIVE PRODUCTS
MSDS Date:03/21/1995
FSC:5350
NIIN:00N063106
MSDS Number: BYVMW

NORTON CO

1 NEW BOND ST
WORCESTER, MA 01615
US

Emergency Phone: 508-795-5000

Info Phone: 508-795-5000

Cage: 44197

NORTON CO

15008 WORCESTER, MA 01606-0008 US

Telephone: 508-795-2690/508-795-5000

Cage: 44197

ZIRCONIUM OXIDE

CAS: 1314-23-4

RTECS: ZH8800000

Fraction By Weight: 30-50%

OSHA PEL N/K

ACGIH TLV: N/K

3); (ALUMINUM OXIDE) (SARA 313)

CAS: 1344-28-1

RTECS: BD1200000

Fraction By Weight: 40-90%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

CURED RESIN; (CURED PHENOLIN RESIN)

Fraction By Weight: 3-12%

OSHA PEL N/K

ACGIH TLV: N/K

FIBERGLASS (FIBROUS GLASS)

CAS: 65997-17-3

Fraction By Weight: .003-10%

OSHA PEL 5 MG/M3 RESP DUST

ACGIH TLV: 10 MG/M3 (<7MICRONS)

SILICON CARBIDE

CAS: 409-21-2

RTECS: VW0450000

Fraction By Weight: 80-90%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

CALCIUM OXIDE

CAS: 1305-78-8

RTECS: EW3100000

Fraction By Weight: 1-5%

OSHA PEL 5 MG/M3

ACGIH TLV: 2 MG/M3

SILICA, CRYSTALLINE - QUARTZ

CAS: 14808-60-7

RTECS: VV7330000

Fraction By Weight: 0.001-1%

OSHA PEL SEE TABLE Z-3

ACGIH TLV: 0.1 MG/M3 RDUST

BARIUM SULFATE

CAS: 7727-43-7

RTECS: CR0600000

Fraction By Weight: 1-7%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

FLUORIDES

Fraction By Weight: 2-10%

OSHA PEL N/K

ACGIH TLV: N/K

SULFATES & SULFIDES

Fraction By Weight: 1-10%

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHALATION: DUST MAY BE
SLIGHTLY IRRITATING TO EYES AND RESPIRATORY TRACT IN HIGH
CONCENTRATIONS. EYES: DUST MAY IRRITATE EYES. SKIN: SOME MAY
EXPERIENCE SKIN IRRITATION FROM DUST. INGESTION: N O KNOWN ADVERSE
EFFECTS, BUT INGESTION NOT RECOMMENDED. CHRONIC: MAY AFFECT
BREATHING CAPACITY.
Explanation of Carcinogenicity:SILICA, CRYSTALLINE-QUART: IARC
MONOGRAPHS, SUPPLEMENT, VOL 7, PG 341, 1987: GROUP 2A. NTP 7TH
ANNUAL REPORT ON CARCINOGENS, 1994: ANTICIPATED TO BE CARCINOGEN.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHALATION: REMOVE TO FRESH AIR. IF BREATHING HAS STOPPED,
GIVE ARTIFICIAL RESPIRATION. GET MEDICAL ATTENTION IMMEDIATELY.
SKIN: WASH AFFECTED AREAS WITH SOAP AND WATER. OBTAIN MEDICAL
ASSISTANCE. EYE S: WASH WITH LARGE AMOUNTS OF WATER FORAT LEAST 15
MINUTES. OBTAIN FIRST AID AND MEDICAL ASSISTANCE, IF NEEDED.
INGESTION: CALL POISON CONTROL CENTER, HOSPITAL EMERGENCY ROOM OR
MD IMMEDIATELY.

Extinguishing Media:USE MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE SPECIFIED BY MANUFACTURER.

Spill Release Procedures:FOLLOW NORMAL CLEAN UP PROCEDURES.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:ALWAYS HANDLE & STORE WHEELS IN
CAREFUL MANNER, VISUALLY INSPECT ALL WHEELS BEFORE MOUNTING, CHECK
MOUNTING FLAGS FOR EQUAL & CORRECT DIAMETER.
Other Precautions:ALWAYS CHECK MACHINE SPEED AGAINST ESTABLISHED MAX
SAFE OPERATING SPEED MARKED ON WHEEL, USE MOUNTING BLOTTERS, BE
SURE WORK REST IS PROPERLY ADJUSTED, USE SFTY GUARD COVERING AT
LEAST ONE-HALF OF GRI NDING WHEEL, ALLOW NEWLY MOUNTED WHEELS TO
RUN AT OPERATING SPEED, W/GUARD IN PLACE, FOR AT LEAST 1 MIN
BEFORE (SUPDAT)

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR REQUIRED WHEN
AIRBORNE CONTAMINANT LEVELS EXCEED THE TLV.
Ventilation:HANDLE WITH ADEQUATE VENTILATION. SEE OSHA 29 CFR 1910.94
(VENTILATION) AND 29 CFR 1910.1000 (AIR CONTAMINANTS).
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGS .
Other Protective Equipment:USE OF THIS PRODUCT MAY CREATE ELEVATED
SOUND LEVELS. HEARING PROTECTION SHOULD BE WORN WHERE REQUIRED.
(SEE OSHA 29 CFR 1910.134 AND OTHER APPLICABLE REGULATIONS.)
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
OTHER PREC: GRINDING. ALWAYS TURN OFF COOLANT BEFORE STOPPING WHEEL TO
AVOID CREATING AN OUT-OF-BALANCE WHEEL.

Appearance and Odor:SOLID, ODORLESS

Stability Indicator/Materials to Avoid:YES
AVOID ACIDS OF ALL TYPES WITH A PH < 4.0.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:IN USE, DUST IS GENERATED. DECOMP
PRODS, SUCH AS TRACE AMTS OF PHENOL AND/OR FORMALDEHYDE, MAY BE
GENERATED. COOLANTS MAY PRODUCE OTHER DECOMP PRODS.

Waste Disposal Methods:USE STD LANDFILL METH CONSISTENT W/APPLIC FED,
STATE, & LOC LAWS. PRODS W/LISTED FLUORIDES MAY HAVE SLIGHTLY
SOLUBLE FLUORIDE SWARF. MFR RECYCLING PROGRAM: MFR HAS DEVELOPED A
GRINDING WHEEL RECYCLING PROGRAM. IF YOU ARE INTERESTED IN
RETURNING YOUR STUBS, INFO CAN BE OBTAINED BY DIALING (508) 795-5
000.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.